Ms. Magoo Posted June 15, 2020 Report Share Posted June 15, 2020 Has anyone changed the cup holders on the gunwale to a combo rod holder / cup holder? Quote Link to comment Share on other sites More sharing options...
Miss Jazzy Posted June 16, 2020 Report Share Posted June 16, 2020 Haven’t put any in the gunnels yet but I did instal them here..... I plan on putting a couple more in the gunnels but working on a t top right now. You will need to be very careful putting them in the gunnels as there is JUST enough room. A mistake either way and you’ll need a fiberglass man. Quote Link to comment Share on other sites More sharing options...
Ms. Magoo Posted June 16, 2020 Author Report Share Posted June 16, 2020 Thanks for the advice. I am hoping to avoid cutting a new hole and was hoping to remove and replace the current cup holder. I was hoping someone had done this and could give me the heads up on the current hole opening. I might take a shot of removing. Quote Link to comment Share on other sites More sharing options...
RGS Posted July 4, 2020 Report Share Posted July 4, 2020 Was thinking of doing the same thing on my 2400 TRS. Can you tell me where you bought the your combo rod/cup holders? Also did you figure out if you needed to do any cutting to install. Thans, rgs Quote Link to comment Share on other sites More sharing options...
Ms. Magoo Posted July 4, 2020 Author Report Share Posted July 4, 2020 Hi RGS After a bit of trial and error. I installed Mate Series brand that fit the current hole perfectly. They do take a bit of space up under the gunwale but has not been an issue for me since that area is already so long with usable space. They are fantastic. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.