Dmiles Posted December 4, 2020 Report Share Posted December 4, 2020 I have a 2018 2200 trs with 4cyl 200 Yahama. Currently rigged with an Atlas Jackplate and Reliance 3 blade 18. The boat will only run 41 WOT at 4900 rpms and prop slips in when turning and coming out of the hole. I suspect that the Jack Plate is mounted to high. Would appreciate if anyone could share a pic of their set up for me to compare. My pic is not the best but the jack plate is mounted at the top of the transom. Quote Link to comment Share on other sites More sharing options...
HoneyB Posted December 5, 2020 Report Share Posted December 5, 2020 Yes I would say your is mounted much higher than my 2200trs Quote Link to comment Share on other sites More sharing options...
Dmiles Posted December 5, 2020 Author Report Share Posted December 5, 2020 Thanks for the pic. What engine and shaft length is on yours? Quote Link to comment Share on other sites More sharing options...
HoneyB Posted December 5, 2020 Report Share Posted December 5, 2020 20 inch SHO.. also has the setback to total 10 inches back Quote Link to comment Share on other sites More sharing options...
S2KiiNG Posted March 3 Report Share Posted March 3 Did you ever figure this out? I am getting ready to slap my jack plate on in the next month or so. I have a 25" F200. Without the JP I sling an OFX4-16. Did you see a noticeable difference in the boats character after the JP install? I have a brand new Bob's 6" set back waiting patiently in my garage to be installed. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.