Replacement bilge pump recommendations for 2016 2400trs

[fishinfool1]

What have y’all done when it comes to replacing the blue/white cartridge style livewell fill/recert pumps on 2016 2400trs.

 

 

thanks

[jh141]

I change the cartridge's when they go bad. 

I order new two pin Deutsch connectors (I get mine from Jegs)

https://www.jegs.com/i/JEGS+Performance+Products/555/10780/10002/-1?gclid=EAIaIQobChMInZS-5e-y9wIVJm5vBB3WqQXLEAQYASABEgJVMfD_BwE#

I order the Shurflo pump cartridge and install the new connector.  Easy swap when one goes bad. I order the cartridge from whoever has them and is cheapest. 

https://www.westmarine.com/buy/shurflo--piranha-800-1100-cartridge--5379193

Mine have been lasting years so I have stuck with them. If you have a pick up pump not working, check for debris, I have had some kind round seed get into mine and just stop the motor. Cleaning gets it going again. 

 

[tarheeler]

This to I’m curious about as the access on the 24trs to the pump is waaay far from the access hatch unless your stretch Armstrong.

[jh141]

My Bilge Pump is not a cartridge style. My Live well and recirculate pumps are. With the TRS they are right under the seats.

The bilge pump I service through the splash well hatch. The base is screwed down but the pump and internal switch just clip to the base. I use a long slotted screw driver to release the clips and pull the pump up by the hose. I clean the pickup screen and base and put it back. 

26 minutes ago, tarheeler said:

This to I’m curious about as the access on the 24trs to the pump is waaay far from the access hatch unless your stretch Armstrong.