Jump to content

SHAFT SIZE


fin-addict

Recommended Posts

may be looking into a new TM, what shaft size for an 03' 2200v.

present one measures 60" from  bottom of skeg to top of head unit. exposed shaft alone measures 47" from where it comes out of head unit to where it goes into motor. do not know where they are measured from.

thinking of going with MG Xi5 w/gps 24v, 60" or 54". any suggestions, want to stay w/24v.

there goes my $$$$$$ for a pp :( unless I can get the tm working correctly.

 

Link to comment
Share on other sites

26 minutes ago, Bamaskeet said:

A 54" will work if you only fish in flat water.  If you plan to fish lumpy water, you will be happier with a 60" trolling motor.

Ditto.....  

If you are going to spend considerable time on big water, there is no reason not to have the longer shaft.  The inconvenience of 6" more sticking up when fishing skinny water is far outweighed by the 6" more sticking down in bumpy stuff.

Link to comment
Share on other sites

Honestly don't worry about Powerpole. The new trolling motors are more valuable and versatile in my opinion. Not that they aren't nice- but as someone who has a Powerpole and no GPS trolling motor; I'd rather swap. Powerpole is for 8ft of water.. ipilot can help with bridge and pass fishing etc which I do much more often

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...