david Terry Posted April 12, 2018 Report Share Posted April 12, 2018 I posed about this in thread title 20v question. So I have cable pull lines on starboard side of anchor locker, in the console on port side and rear starboard hatch. None of the lines move when I try and pull them through. They seem stuck. Any advice on this? I’m thinking about greasing upba snake and seeing if I can push that through. Thanks a lot Link to comment Share on other sites More sharing options...
Grant Posted April 13, 2018 Report Share Posted April 13, 2018 If you acquired the 2000V used, it is possible someone tried to pull something through and wedged it tight. I had a connector break off once. I was lucky enough to recover it a couple years later ! It's no trouble to fish a line from the console to the rear bilge bypassing the factory cable routing. I think it's easier than using the factory pulls, but I haven't run a line to the bow outside of the conduit. If your bow pull cord is wedged it ought to be possible to yank it loose as long as youre pulling in the right direction. Wrap it around a dowell to get a good grip ? Otherwise it sounds like fishing a new route is in the works. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.