Bayfisher34 Posted April 16, 2018 Report Share Posted April 16, 2018 Getting cushions made on my flats boat and was asked to measure from the rod holders to the bulkhead. What's the bulkhead ? Link to comment Share on other sites More sharing options...
justfish Posted April 16, 2018 Report Share Posted April 16, 2018 The vertical “wall” that goes from deck to cockpit floor Link to comment Share on other sites More sharing options...
bernieNC Posted April 16, 2018 Report Share Posted April 16, 2018 Question is what's that got to do w/ cushions? Link to comment Share on other sites More sharing options...
hurricane Posted April 16, 2018 Report Share Posted April 16, 2018 16 minutes ago, justfish said: The vertical “wall” that goes from deck to cockpit floor I assume thats how they determine how deep to make the cushion. From the bulkhead edge to the rod holder. Link to comment Share on other sites More sharing options...
fin-addict Posted April 16, 2018 Report Share Posted April 16, 2018 I would think that it would be to where the cushion will sit to the top of the gunnel for the ht. Bulkhead, wall from deck to cast decks fore and aft not the side walls. A wall between two spaces. Link to comment Share on other sites More sharing options...
Bayfisher34 Posted April 16, 2018 Author Report Share Posted April 16, 2018 5 hours ago, bernieNC said: Question is what's that got to do w/ cushions? There are two "rod holders" around the livewell so I assume she wants to see how wide the cushion needs to be (from the bulkhead to the livewell) I'm also getting a bench inserted in these "rod holders" so probably has to do with that. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.