Williep Posted January 25, 2019 Report Share Posted January 25, 2019 Made a few upgrade's to my 2001 2200V, added a new bluetooth radio, speaker's, 2 new splash cover's and pedestal seat's. The rear base plate's for the seat's were kind of a pain in the butt, after I cut out a 6 1/2" hole for the access cover's I had to cut out enough foam so I could bolt down the base plate's with 1/4" bolt's with fender washer's and nylon lock nut's, it was just time consuming. The front base plate's weren't as bad, I just had to get someone to hold backup while I tighten the nut's. All hardware used was stainless. I should have taken pic's while doing these project's but I didn't think of it at the time. . Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.