2200TRS Posted April 5, 2019 Report Share Posted April 5, 2019 Hi Everyone, I am adding two pathfinder rod holders to my 2016 2200 TRS. They will be located just short of the front lockers. Does anyone happen to know the hole saw diameter I need to make the hole? The dealer said Pathfinder only has one model rod holder so the holes should be standard across all models. Link to comment Share on other sites More sharing options...
HoneyB Posted April 5, 2019 Report Share Posted April 5, 2019 The rod holder itself should be two inch OD. You can use a two inch hole saw but might need to open it up a touch. If you are installing pathfinder logo rod holders they are 30 degree. The trick is to drill your hole on the angle you need . Link to comment Share on other sites More sharing options...
2200TRS Posted April 6, 2019 Author Report Share Posted April 6, 2019 Yes they are Pathfinder logo rod holders. I’m going to give it a shot tomorrow. Thanks for the info. Link to comment Share on other sites More sharing options...
HoneyB Posted April 6, 2019 Report Share Posted April 6, 2019 Start your drill bit . Before the hole saw starts to cut lean it to the correct angle. Use a tri square or even stand the rod holder up behind your drill bit to find the angle Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.